RB-400

 The RB-400 antenna mount is designed to mount around a panel edge.  It is attached by clamping around the panel, with 4 grub screws and a pressure bar underneath.  The upper side of the panel is protected by a soft layer that adds to the stability of the installation.  The mount is designed to support medium sized antennas; the clamping bracket is approximately 100mm in length.  The antenna support is adjustable in vertical and horizontal rotation, about the clamping base,  to provide the desired antenna alignment.

Note: the RB-400 has a stabilising tab that extends beyond the panel that it is mounted to.  This in intended to contact an adjacent panel when the mounting panel (boot, bonnet etc) is closed.  This tab could interfere with opening of the boot / bonnet, if mounted on the hinged edge of the opening panel ( depending on the hinge action).   The RB-700 mount is an option in this case - it does not have the additional tab.  Alternatively, the RB-400V, in a smaller footprint, also does not have the same tab.

The RB-400 bracket is manufactured in black finish stainless steel.